How to Install Your APlusLift MT1500X

How to Install Your APlusLift MT1500X

The APlusLift MT1500X, as we know, is a lift that's used for larger cars like SUVs and pickup trucks.apluslift mt1500x However, the APlusLift does more than that. This lift will work on older cars as well as on vans. Here are some tips to help you get started with your APlusLift MT1500X:

o It goes very smoothly, so you can get your job done very quickly.apluslift mt1500x apluslift mt1500x The APlusLift is a huge truck, so it will go through no problem doing its job. The only time that you might have to wait for your job to be done is when there is a second set of people involved in the construction or repair process.

o Start by measuring the dimensions of your vehicle.apluslift mt1500x apluslift mt1500x The Lift Company recommends using the overall length of the vehicle plus two feet plus two inches for the width of the vehicle. That way, you'll be able to get an accurate measurement of how much space you need to work with in order to move around.

o Go to Home Depot and pick up some plywood and some glue.apluslift mt1500x Measure your space the APlusLift will be working in, and then tape down the measurements. You'll use these to help determine the exact measurements for the plywood to use. For this reason, it's good to make sure that the plywood is kept clean and in the best condition possible before painting.

o The first step in getting your APlusLift out of the garage and onto the road is to put the plywood on top of your vehicle. Start by using the pliers to break up the corners of the plywood to ensure that the corners are even with the corners of the box. You will want to make sure that the plywood does not stick out too far from the edges. You will need to make certain that the length of the plywood matches up with the length of the box as well.

o Attach the plywood to the box. After all of the pieces of plywood are attached, you will want to put a few washers under the plywood. Then, attach the bolts that go under the washers. Remember, the length of the bolts has to be consistent throughout the box.

o Now, measure the amount of space that the Box Company recommends. Find a spot in the box where you will be working on your vehicle. It's okay if the space that you have on the outside of the box isn't even with the spot where you're going to put the APlusLift. You can still make it fit with just a little bit of careful measuring and marking.

o Take your mounting screws and gently bend them until they're snug. Then, put the screws on the plywood and use them to secure the plywood in place. Tighten them down to help prevent your APlusLift from shifting.

Tags:apluslift 1500lb